Post your videos as file attachments here. One video per topic please!

Moderators: sg, mods

User avatar
By pec1985
Testing a new camera mount. It's just an old batten with a GoPro attached to the tip, then the other end duct taped to the front keel tube. It wobbles and wiggles.

But the view is cool

User avatar
By pec1985
This is the mount:
52351156893__625D06BD-5A6F-4FA3-8F90-EB7F022CBCE3.JPG (44.68 KiB) Viewed 848 times
User avatar
By Windlord
Maybe shorten the rib a little or cram a dowel into it to keep it from flexing so much.
The attachment portion could be more solid?
Very clean setup though. :thumbsup:
User avatar
By raquo
Try putting a line between the camera and where you're holding it with your hand, it will reduce wobbling at least in one direction. For this to be effective the line needs to be tensioned, perhaps to the extent that the batten is slightly bent due to tension. But not too much, you don't want permanent deformation.

This line can also double as a safety leash for the camera.

Disclaimer: tensioning a line like that will put additional load on the batten, it might buckle under less load that way.
User avatar
By Nicos
Love that angle!

Could always add a sleeve to the straight bit. Or fill it with carbon fibre..
Getting a smaller/lighter camera like a Mobius (super cheap but quite good) will help no end.

Man, a 2-axis gimbal from that angle would rock out bigtime!

I tried that in my Aeros Myth 2 harness and it did[…]


OK, I love teaching, have done a lot of mentoring […]

Delta Club Bratislava

Let me introduce you the latest compilation 2017 o[…]

Birds Eye view!

Pretty amazing footage from an Eagle in Dubai. ht[…]