DanJ wrote: ↑
Wed Oct 03, 2018 8:46 pm
What is a good configuration for storing a glider in a garage? For 3 support points, can anyone recommend a good padded arm hanger that is big enough for a glider in its bag? Or do you use some other way/make your own? Are there bigger/better ones out there for hang gliders?
And do you also leave the bag unzipped a little to make sure no moisture gets trapped in to create mildew? Anything else we need to know about winter storage? This will be my first winter with it and I need to start preparing. Thanks
I make my own glider storage shelves, but not with padding. I use two of these brackets to support a 1"x12"x72" board.
https://www.amazon.com/Alise-J5207-4P-S ... ckets&th=1
Each pair of brackets will be about 48" apart, with the shelf board centered on the pair. I make one such shelf for each end of the glider. These two shelves are at the same height, and about 40"~50" apart horizontally. Each shelf holds half of the glider's weight. It will be easier to load or unload the glider if the storage shelves are a little less high than shoulder height, but suit yourself. No padding is needed; padding holds moisture.
Tack a guiding string-line horizontally and tight across the wall where the glider shelf will be. Make the string-line as long as the glider. Using the guiding string-line to keep your shelves straight; pre-drill the wall studs for the heavy mounting bolts that will hold the shelf brackets. Use 1/4" or 5/16" thick lag bolts to attach the shelf brackets to the wall studs. Put the shelf board on top of each bracket. Use short Allen-head wood screws (less than 7/8" long) from underneath to attach the shelf to the bracket. A power-drill with an Allen Apex bit can drive these short screws without pre-drilling.
If moisture is a concern, you can get Silica Gel desiccant packets. For storage, distribute at least two dozen of these packets inside along the length of the glider bag, then close the zippers.
https://www.amazon.com/DRY-Premium-Indi ... +desiccant
When good, these crystals are bright blue, and ready to absorb moisture. When saturated, the crystals will turn pale, white, or even pink, so you will know when to replace them. These packets are renewable; just bake the saturated packs in an oven at about 200 F (94 C) degrees for about three hours. They will change back to bright blue crystals again, ready to work again. Store the blue crystals in an airtight container, when not in use. Check the color of the crystal packs now and then in your glider bag, and replace any packets that are not blue.
Do not let liquid water get on or under the glider bag, of course.